Putty for engines 310g - red

K2 SILICONE RED - silicone for sealing engine parts during assembly

High quality silicone, safe for lambda probes, on-board computers, meets the requirements of car manufacturers (OEM - Original Equipment Manufacturer). It replaces traditional cork, paper, felt, asbestos and rubber seals. Thanks to the SENSOR SAFE formula, it does not damage lambda probes in modern cars with electronic fuel injection.

Resistant to oils, lubricants, coolants, etc. Applicable to all types and brands of cars for sealing thermostat compartment lids, oil pans, water pump lids, cooling joint terminals, and more. Resistant to temperatures up to 350 ° C.

Instructions for use: 1. The surface must be dry, free of dust, dirt and grease. 2. Remove the old, loose seal. 3. Apply a small amount of silicone (any excess can be removed with a knife soaked in soapy water). 4. Silicone starts to dry after 5 minutes and after 1 hour it is resistant to touch, complete drying occurs after 24 hours. 5. Excess dried silicone can be removed with a razor blade.