Silicone for sealing engine parts - black 85 g

K2 SILICON BLACK 85g - is a high quality silicone, safe for lambda probes, on-board computers, meets the requirements of car manufacturers (OEM - Original Equipment Manufacturer). It replaces traditional cork, paper, felt, asbestos and rubber seals. Thanks to the SENSOR SAFE formula, it does not damage lambda probes in modern cars with electronic fuel injection. Resistant to: oils, lubricants, coolants, etc. Applicable to all types and brands of automobiles for sealing: thermostat compartment covers, oil pans, water pump covers, cooling joint terminals, and others. Resistant to temperatures up to + 350 ° C.

Instructions for use: The surface must be dry, free of dust, dirt and grease. Remove the old, loose seal. Apply a small amount of silicone. Any excess can be removed with a knife soaked in soapy water. The silicone starts to dry after 5 minutes and after 1 hour it is resistant to touch. Complete drying occurs after 24 hours. Excess dried silicone can be removed with a razor blade. The tube must be properly closed after each use.